Cantilever Bridges

This topic contains 2 replies, has 2 voices, and was last updated by  Michael Zichterman November 19, 2015.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #4982

    Michael Zichterman
    Participant

    I have 2 cases , 3 unit cantilever bridges.  The E4D system “errors out” at the mill stage.  Any Help out there?

    #9943
    Mike Kelliher
    Mike Kelliher
    Keymaster

    Yeah you need to trick the software by designing something on the other side of the pontic.  Can be just a little wind that you’ll grind off post mill, but the software does need what it considers abutments on either side.  Here’s a video Wally did on single wing Maryland type bridges and how he does that design.

     

    https://learndigitaldentistry.com/video/e-max-adhesion-maryland-bridge/

    #9944

    Michael Zichterman
    Participant

    Thanks Mike, I reset the case and with this modification am milling now.  

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.