Possible Future Software Addition…

This topic contains 2 replies, has 3 voices, and was last updated by  Dr. Damon Jenkins August 21, 2016.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #5043

    Shanalee
    Participant

    Is there any possible way, in future software updates, to make it so that while in the Mill tab you can see how much time it would take to mill? You could move the sprue, change from standard to detailed, and it would change the time accordingly?!

     

    Just a thought!  🙂

    #10223
    Mike Kelliher
    Mike Kelliher
    Keymaster

    That’s a good thought. Laptop software would I think have to build the tool path to calculate the mill time, probably possible.

    #10224

    Dr. Damon Jenkins
    Participant

    We use to be able to check the mill time from the software. Only during milling not before. It would be nice though.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

Login

Don't have an account? Registration is free and only takes a minute.

Register